Azilsartan Medoxomil

製品コードS3057 バッチS305702

印刷

化学情報

 Chemical Structure Synonyms TAK-491 Storage
(From the date of receipt)
3 years -20°C powder
1 years -80°C in solvent
化学式

C30H24N4O8

分子量 568.53 CAS No. 863031-21-4
Solubility (25°C)* 体外 DMSO 114 mg/mL (200.51 mM)
Water Insoluble
Ethanol Insoluble
* <1 mg/ml means slightly soluble or insoluble.
* Please note that Selleck tests the solubility of all compounds in-house, and the actual solubility may differ slightly from published values. This is normal and is due to slight batch-to-batch variations.

溶剤液(一定の濃度)を調合する

生物活性

製品説明 Azilsartan Medoxomil (TAK-491) is a potent angiotensin II type 1 (AT1) receptor antagonist, inhibits the RAAS, with an IC50 of 2.6 nM, exhibits >10,000-fold selectivity over AT2.
in vitro Azilsartan medoxomil is a prodrug, which is rapidly converted to the active moiety, azilsartan (TAK-536), by ester hydrolysis in the gut and plasma during absorption after oral administration. Azilsartan selectively blocks the binding of angiotensin II to the AT1 (angiotensin II type 1) receptors found in the vascular smooth muscle and the adrenal gland, thereby promoting vasodilation and a decrease in the effects of aldosterone. [2] Azilsartan is a highly selective antagonist to the AT1 receptor, with an IC50 of 2.6 nM, exhibiting a >10,000-fold affinity for the AT1 receptor compared with the AT2 receptor, and has not shown affinity for other cardiac receptors or ion channels. The inhibitory effect of Azilsartan persists after washout of the free compound (IC50 value of 7.4 nM). Azilsartan also inhibits the accumulation of angiotensin II -induced inositol 1-phosphate (IP1) in the cell-based assay with an IC50 value of 9.2 nM, and this effect is resistant to washout (IC50 value of 81.3 nM). [1]

プロトコル(参考用のみ)

キナーゼアッセイ Radioligand Binding
A radioligand binding assay is performed by using human AT1 receptor-coated microplates containing 4.4 to 6.2 fmol of receptors/well (10 μg of membrane protein/well). Membrane-coated wells are incubated with 45 μl of assay buffer (50 mM Tris-HCl, 5 mM MgCl2, 1 mM EDTA, and 0.005% CHAPS, pH 7.4) containing various concentrations of test compounds at room temperature. After 90 min, 5 μl of 125I-Sar1-Ile8-AII (final concentration 0.6 nM) dissolved in assay buffer is added to the wells, and the plate is incubated for 5 h. In each step, the plate is briefly and gently shaken on a plate shaker.
細胞アッセイ 細胞株 COS-7
濃度 ~10 nM
反応時間 2 h
実験の流れ Measurement of Inositol 1-Phosphate Accumulation. Twentyfour hours after transfections with human AT1-expressing plasmids, the cells are starved by changing the culture medium to starvation buffer (1 mM CaCl2, 0.5 mM MgCl2, 4.2 mM KCl, 146 mM NaCl, 5.5 mM glucose, and 10 mM HEPES, pH 7.3). Then, 5 μl/well of the test compounds dissolved in starvation buffer is added to the cells at the indicated concentrations, and they are pretreated for the indicated times. Two hours after starvation, LiCl is added to a final concentration of 50 mM with or without angiotensin II 10 nM, and the cells are further incubated for the indicated times at 37°C. In washout experiments, the cells are washed once with 100 μl/well of starvation buffer to remove unbound compounds before stimulation with angiotensin II. The accumulation of inositol 1-phosphate (IP1) is measured by using a IP-One Tb kit. The fluorescence resonance energy transfer signal is measured on a plate reader.

カスタマーフィードバック

, , Sci Rep, 2015, 5:8116.

Selleckの高級品が、幾つかの出版された研究調査結果(以下を含む)で使われた:

Suppression of adrenal barrestin1-dependent aldosterone production by ARBs: head-to-head comparison [Dabul S, et al. Sci Rep, 2015, 5:8116] PubMed: 25631300

長期の保管のために-20°Cの下で製品を保ってください。

人間や獣医の診断であるか治療的な使用のためにでない。

各々の製品のための特定の保管と取扱い情報は、製品データシートの上で示されます。大部分のSelleck製品は、推薦された状況の下で安定です。製品は、推薦された保管温度と異なる温度で、時々出荷されます。長期の保管のために必要とされてそれと異なる温度で、多くの製品は、短期もので安定です。品質を維持するが、夜通しの積荷のために最も経済的な貯蔵状況を用いてあなたの送料を保存する状況の下に、製品が出荷されることを、我々は確実とします。製品の受領と同時に、製品データシートの上で貯蔵推薦に従ってください。